Are you looking to buy LDO Nitehawk SB Toolboard Kit in Australia?
Nitehawk-SB by LDO is a toolboard specifically designed for the Voron Stealthburner toolhead. It is a toolhead PCB featuring RP2040 MCU, TMC2209 stepper drive, ADXL345 accelerometer all integrated into one board. The form factor of Nitehawk is based on HartK’s two piece stealthburner toolhead PCB but with some minor changes.
Nitehawk uses USB communication with the RPI rather than CAN. So the software and hardware setup is far simpler and familiar to most people who have setup Klipper printers before.
Features
- Convenient wiring, no more complicated and error prone breakout cables - nitehawk only requires 24V power and a USB connector to the RPI host.
- USB Klipper connection, no additional software or hardware setup compared to CAN
- Custom toolhead cable, a single combined USB data and power cable rated for drag chain use, but can also be used in umbilical configuration.
- Convenient Input Shaping, run input shaper calibration at anytime with an onboard accelerometer.
Tacho enabled fans, both hotend and part fan ports are three pin tachometer compatible, allowing for additional diagnostics and safety.
Overview
The Nitehawk system consists of three PCBs and the Umbilical Cable. A simplified wiring diagram is shown below:
- Nitehawk-SB, this is the main PCB, which houses the MCU, stepper driver, fan drivers, and other circuits.
- Fan Adapter, this is simple PCB receives the part fan, hotend fan, and neopixels and connects them to the main Nitehawk PCB via headers. The main purpose of this seperation is to allow the Stealthburner front to be easily detactable for maintenance.
- Umbilical Cable, this is a custom flex cable that is rated for drag chain use. It delivers 24V power to the main Nitehawk PCB while also carrying USB data.
- USB Adapter, this simple PCB combines 24V power from the power supply and USB data from the Raspberry Pi into a unified connection to the main Nitehawk PCB via the Umbilical cable.
For installation information and setup see the LDO documentation.
Includes
- 1x Toolhead PCB
- 1x USB Adapter PCB
- 1x Stealthburner fan adapter
- 1x USB Umbilical cable (2.1m)
- 1x USB-A to USB-C data cable (0.3m)
- 1x 24V power cable
- 2x Machine screw, captive M3x6 (door cover)
- 3x Machine screw BHCS M3x8 (PCB to toolhead side)
- 4x Machine screw SHCS M3x10 (Fan to PCB to SB fan shroud)
- 1x MX3.0 male connector 3x2pin
- 8x MX3.0 female crimp terminal
- 1x XH2.54 female connector 2pin
- 1x XH2.54 female connector 3pin
- 2x XH2.54 female connector 4pin
- 20x XH2.54 female crimp terminal
- 1x XH2.54 female connector 2pin
- 3x XH2.54 female connector 3pin
- 12x XH2.54 female crimp terminal
- 4x ferrule 1008
- 4x ferrule 0508
Browse more
- Browse all LDO
- Browse all Extruders
- Browse all Voron Parts and Accessories