Are you looking to buy TBS Lucid DroneCAN Airspeed Sensor in Australia?
The TBS Lucid DroneCAN Airspeed Sensor features CAN JST-GH connector, DroneCAN Protocol and direct I2C support. It comes with a stainless steel pitot tube and silicone tubing, ready to be installed in your project.
Specifications
- CAN & I2C Interface
- CAN JST-GH connector, DroneCAN Protocol
- I2C JST-GH connector, MS4525DO I2C mode (I2C address 0x28)
- CAN status LED, Orange
- Fast blinking, No communication between CAN node and Flight Controllers
- Slow blinking, Communicating between CAN node and Flight Controllers
- 3.3V Power LED, Orange
- Input voltage range: 4~6V
- Power consumption: 60mA
- Operating Temperatures: -20°C to 85°C
- Pressure range：6890kPa
- Airspeed range： 100 m/s or 360 km/h or 223 mp/h
- Accuracy: ±2.0%
- Dimensions：35mm*22mm*12mm
- Weight：4g
Setup
DroneCAN Mode
- Verify the following parameters are set on your autopilot via your ground station.
- CAN_P1_DRIVER = 1 (assuming its on the first CAN bus of the autopilot)
- ARSPD_TYPE = 8 (DroneCAN)
I2C Mode
- ARSPD_TYPE = 9 (DLVR-10)
- ARSPD_USE = 1 to enable using the sensor on autopilots external I2C bus
Package includes:
- 1x TBS Lucid DroneCAN Airspeed Sensor
- 1x Airspeed Sensor Pitot Tube w/ silicone tube
- 2x CANBUS cable (4pins 20cm)
