Last Updated 25-04-16
The following parts were selected
1x Bolt 250 Frame
1x Naze 32: Naze 32 Acro
4 x XNova 2204 2300kv motors
4x ZTW Spider Mini 18A OPTO ESC Multi-Rotor 2~4S (BLHeli/SimonK Firmware)
1x Foxeer HS1177 XAT600M DC5V-22V 600tvl Sony Super HAD CCD FPV Camera IR Block 2.8mm Lens PAL
1x Aomway T25 5.8GHz Selectable 25/200mW 40CH FPV Tx VTX
1x Aomway 5.8GHz RP-SMA FPV 4 Leaf Clover AV Transmission RHCP Antenna 1 Piece – Red
1x Matek PDB BEC-5V/3A LED Lighting Control Tracker Low Voltage Alarm LED & POWER HUB 5in1
4x DAL Tri Blade T5045BN 5045BN Bullnose Propellers
1x FrSky XSR 2.4GHz 16CH ACCST Receiver with S-Bus and CPPM
1x FrSKY Taranis X9D Plus Mode 2 2.4Ghz Digital Telemetry Radio System With Alluminium Case (C’Tick Approved)
Pictures of progress
Frame Put together, Motors mounted, Camera Mounted
Pins Placed in Naze32
Pins Soldiered in Naze Board
PDB Board installed and wired to ESC power.
Inside a xnova motor
All setup with the X8R installed
Ready for props!
All cables clean
All setup and ready to fly!